logo

Free Shipping

on all orders over $149

truck_

Free Shipping on all orders over $149​

Knowledge Base

How to Change the LED Board on the FC Well Light

Image courtesy of hunter industries

STEP ONE: Turn off power to the transformer completely prior to disassembling the fixture. To remove the FC brass faceplate assembly, remove the six screws along the side of the fixture by turning the screws counterclockwise using a Philips screwdriver.

Image courtesy of hunter industries

STEP TWO: Remove the faceplate and lens assembly by lifting upward.

Image courtesy of hunter industries

STEP THREE: Turn filters counterclockwise and pull up to remove.

Image courtesy of hunter industries

STEP FOUR: Depending on the size of the LED board, two or three Phillips head screws are required to be removed to access the LED board. Carefully remove these screws by turning each counterclockwise.

Image courtesy of hunter industries

STEP FIVE: Remove the LED board using a small flat head screwdriver, gradually prying a section of the board and repeating this process around the perimeter of the board.  Clear all debris or residual thermal pad material from the fixture base.

Image courtesy of hunter industries

STEP SIX: Once the LED board is successfully removed, perform this procedure backward to install the replacement board. Not all boards will fit in every fixture, so ensure the fixture can accommodate the selected board prior to maintenance. Also remove any residue left on the fixture from old LED board prior to installation of the new one. All FX LED boards come with a pink colored thermal pad attached to the bottom that should be left in place.

 

Leave a Comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.