Knowledge Base

How to Connect Hunter Pump Start Relay to Power Source

PSR-Connect-Power-Source-2
Image courtesy of hunter industries

NOTE: Connecting the Pump Start Relay should only be done by a licensed electrician following local codes. Improper installation could result in shock or fire hazard.

  1. To prevent electric shock, turn the main circuit breaker switch to “off” prior to making any electrical connections.
  2. Assemble conduit piping and connect AC power from the power source to one side (LINE IN) of the relay.
  3. Assemble conduit piping and connect wiring from the pump motor to the other side of the relay (LOAD OUT).
  4. Check to make sure there are no exposed or loose connections.

 

Leave a Comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.