How to Connect a Pump Start Relay to Hunter Pro-C
Route a wire pair from the pump relay into the controller housing. Connect the pump common wire to the terminal …
Route a wire pair from the pump relay into the controller housing. Connect the pump common wire to the terminal …
Connect a 9-volt alkaline battery (not included) to the battery terminals and place in the battery compartment in the front panel. The …
Below is a chart indicating the maximum wire runs that can be used when installing Hunter AC solenoids and valves. …
Route valve wires between control valve location and controller. At valves, attach a common wire to either solenoid wire of …
The Pro-C controller is supplied with a factory-installed base module for up to 4 stations. Additional modules may be added …
INDOOR CABINET Route transformer cable through the hole on the bottom left side of the controller and connect one Yellow Wire to …
ALL NECESSARY HARDWARE IS INCLUDED FOR MOST INSTALLATIONS. Use the hole at the top of the controller as a reference …
The Pro-C controller can activate 2 Hunter Solenoids per station terminal plus a master valve.